149992-01 BENTLY 

149992-01 BENTLY

149992-01 If you select 1X Phase Lag or 2X Phase Lag, these two optionsAvailable with and without lag. 149992-01 If the channel is bypassed, thenThe output will be clamped to the selected clamping value or 2mA (if 2mA149992-01 Hysteresis option helps prevent recorder output jumpsFrom full scale to full scale when the phase measurement is close to 0 or 359Degrees

When the hysteresis option is selected, the recorder signal operates as follows:

The recorder output is scaled so that 4mA corresponds to 0 degrees

And 20 mA correspond to 149992-01 to 380 degrees (360 plus 20 degrees).

No additional phase measurement transitions will occur

Until the measured value exceeds 360 degrees and 20 degrees. Here

Point, the recorder signal switches from 20mA to one signal

Corresponds to 20 degrees or 4.842 mA.

The reduced phase measurement transition occurs at 0

Degrees (4 mA). At this time, the recorder signal switches from 4mA to

Corresponds to a signal of 360 degrees or 19.158 mA.

149992-01 The time that the proportional value must remain at or above the alarm level

Or below the alert level before the alert is declared active.

alert

When the sensor signal level exceeds

Selected Alert/Alarm 1 setpoint. This setpoint can be set on the setpoint

Screen. The alarm time delay is always set to a one second interval (from 1

To 60) for all available proportional values.

danger

Secondary alarm that occurs when the sensor signal level exceeds

The selected Danger/Alarm 2 setpoint. This setpoint can be set at

Setpoint screen.

100 ms option

The 100 millisecond (typical) option is only available for dangerous time delays and

The following results were obtained:

If the 100 ms option is turned off ():

The danger time delay can be set to a one second interval (from 1

To 60).

twenty-one

Manufacturer:Bently Nevada

Article No.:149992-01

Product type:Spare 16-channel relay output module

Made in the United States

Certificate of Origin(COO)can be added

Shipping weight:3 kg