350050 133442-01 BENTLY
3500/50133442-01 Physical distance between the surface of the proximity probe tip and the probe
Observed surface. The distance is expressed in voltage. standard
According to the polarity convention, reducing the gap leads to an increase
(Reduce load) Output signal.
3500/50 133442-01 These fields contain information indicating which module you are configuring.
channel
The channel numbers being configured (1 to 4).
a slot
The position of the monitor in the 3500 rack (2 to 15).
rack type
Identify the type of rack interface module installed (Std or TMR).
Enable
Peak to Peak
Difference between positive and negative poles of 3500/50133442-01 rotor
Bow. The proportional value is only available on keyway props
Selected. This value may be displayed in mils or micrometers.
Direct
Instantaneous eccentricity value. Can display direct values
When the shaft speed is greater than 600 rpm, the direct value is
The average distance between the probe tip and the axis, and display
In a manner similar to thrust measurement. This direct measurement is
3500/50 133442-01 is only displayed when direct channels above 600rpm are enabled.
-The shaft speed is between 600 rpm and the rpm setting
Instantaneous crossover, direct measurement includes two
Value: The maximum and minimum values relative to the zero reference.
These two direct values are called Direct Max and Direct Min.
-The shaft speed is lower than the instantaneous speed setting
Crossover, Direct Max, and Direct Min are equal, directly
Measurement includes relative to an instantaneous measurement
Zero reference. This direct measurement is called
Instantaneous time gap
CPT Word Processor 8080 CPU Board 910305 R6
CPT Word Processor 8080 CPU Board 910305 R7
KODAK M-7B CPU BOARD MAIN BORAD X-RAY FILM
HP HEWLETT PACKARD D3334-60001 LS5/100 CPU BOARD
Digital M7270 KD11-HA DEC PCB CPU Board
