AAI143-S00 YOKOGAWA
The AAI143-S00 is a Yokogawa analog input module that can be used with various Yokogawa controllers and distributed control systems. This module provides a single channel for measuring analog signals in the range of -10V to +10V or -100mV to +100mV.
The AAI143-S00 module has the following specifications:
- Input type: Single-ended
- Input range: -10V to +10V or -100mV to +100mV
- Input impedance: 1Mohm (10V range), 10kohm (100mV range)
- Conversion time: 100ms per channel
- Accuracy: ±0.1% of span
- Isolation: 1500V AC for 1 minute between input and backplane
- Power consumption: 0.9W
The AAI143-S00 module can be configured using Yokogawa’s configuration software or via the controller’s front panel interface. The module supports various diagnostic features, including open/short detection, sensor break detection, and input signal monitoring.
Overall, the AAI143-S00 is a reliable and accurate analog input module that can be used in a wide range of industrial applications.
Wiring
The wiring for the AAI143-S00 module is as follows:
- Connect the positive wire of the analog signal to the “+” terminal of the module.
- Connect the negative wire of the analog signal to the “-” terminal of the module.
- Connect the shield wire to the “SG” terminal of the module.
Configuration
The AAI143-S00 module can be configured using the YOKOGAWA configuration software. The input type, input range, and other parameters can be set using the software.
The AAI143-S00 module can be installed in any available slot in the YOKOGAWA system. The module should be installed with the power off to prevent damage to the system.