2N3A3110-C TOSHIBA

Toshiba module TOSHIBA 2N3A3110-C, 2N3A3620-B, 2N3A8130-A, 2N3A3120-D Toshiba module, Toshiba IGCT module

Established in 1875, Toshiba Group is committed to striving for the future of humanity and the Earth, striving to become an enterprise group that can create rich value and contribute to the lives and culture of all humanity. The business areas of Toshiba Group include digital products, electronic components, social infrastructure, home appliances, etc

Toshiba module TOSHIBA 2N3A3110-C installation and debugging

Ensure that 2N3A3110-C completes power wiring before setting the address

.2N3A3110-C first sends the internal unit power before sending the external unit power.If the outdoor unit is turned on before the indoor unit is turned on,the 7-segment display code on the P.C.board of the external unit will display E19 until the indoor unit power is turned on.

Automatic addressing may take ten minutes(normally 5 minutes)

Automatic addressing requires outdoor unit operation.(Only turning on the power cannot automatically address.)

Automatic addressing will use the SW15 button on the P.C.board interface of the outdoor unit

1.First,power on the indoor unit,and then power on the outdoor unit.

2.After the power is turned on,confirm that the 7-segment display board on the P.C.board interface of the outdoor host shows U.1.L08(at this time,U.1.flashes)

3.Press SW15(the 7-segment display board has changed and is released,usually about 3 seconds)to start automatic addressing(usually 5 minutes).

4.7 segment display indicates Auto1,then Auto2 to Auto3

Indication U.1.-(U.1 Flashing)starts flashing on the display.Flashing stops the display from displaying U.1.-(U.1.light remains on),and the setting is complete.

A set of 16-bit rotary switches allows easy configuration of VME short I/O and memory addresses. Interrupt routing from an IP slot to a VME IRQ can be done in two ways: by software programming or by rotating switches to select a predefined set. Four 50-pin 0.1-inch flat ribbon cable connectors are mounted on the front panel of the TVME200, providing access to all IP I/O lines. In addition, on TVME200-20R, all I/O lines for “IP D” are routed to VME P2, and 14 user-optional I/O lines for “IP C” can be routed to VME P2 via the jumper field. Provides IP access status indicators, +5 V and +/-12 V. IP power cables are protected by self-healing wires and filtered by rf. Operating temperature range is between -40°C and +85°C. Characteristics of the Dimensions: VMEbus board, 6U VMEbus slave interface: – Short I/ OS: A16 and D08/16. Size: 1 KB – Standard memory: A24, D08/16 – Size: programmable, 32 KB to 2 MB per IP – Extended memory: A32 and D08/16 – Size: fixed, 8 MB per IP address – Interrupt: IRQ1-7 IndustryPack module ANSI/VITA 4-1995 compatible interface – IndustryPack slots: four single size or two

The 2N3A3110-C control board is also a type of circuit board, and its usage range is not as wide as circuit boards, but it is better than

Ordinary circuit boards are more intelligent and automated. Simply put, a circuit board that can play a control role can be called a

Control board. The 2N3A3110-C control panel is used for everything from automatic production equipment to remote-controlled cars with children’s toys

Internal