50022M 138607-01 BENTLY

50022M 138607-01 BENTLY

describe

138607-01 can be used when the Keyphasor is not available. If marked asThe only data available are Direct and Gap. This field will138607-01 channel pairs automatically marked as unnecessaryKeyphasor sensors (such as thrust position and differentialExpansion).BasicThe selected Keyphasor channel for 138607-01 is typically used for measurement.When this Keyphasor sensor is marked as invalid, backupThe Keyphasor sensor will provide shaft reference information.backupsThe selected Keyphasor channel will be used when the primary channel is activeKeyphasor failed. If you do not have a spare Keyphasor, select the sameThe Keyphasor channel that serves as the primary Keyphasor.

Configuration software screens related to radial vibration channels.3.1.21 Precautions for radial vibration channel configurationConsider the following before configuring a radial vibration channel:-Internal barrier 1/0 module and external barrier currently do not haveSupports 7200 11 mm or 14 mm, 138607-01 or 3000 proximitors, or 330016Mm HTPS.-When“No Keyphasor” is selectedthe 1X Amplitude(Ampl)and Phase Lag2XAmplitude (Ampl) and Phase Lag, 138607-01 Non 1X Amplitude (Ampl) and SmaxAmplitude (Ampl) cannot be selected.

-If a Keyphasor channel is selected, the Keyphasor module must be installed in theframe.-The allowable full-scale options for each proportional value depend onType of transducer.-If a non-standard sensor is selected, the setpoint OK limit is set to+1From the selected OK upper and lower limits of volts.-There are two options for the 3000 Series sensors:3000 (- 24V) Proximitor

Connect the 3000 Series Proximitor directly to the3500 monitor, but proximitor power is provided from external 18Voltage source. The default scale factor of 200mV/mil will be selected, whichCan be adjusted by+15%. Please note that on the buffer transducerDisplay front and data manager not compensatedAnd should be interpreted as 200 mV/mil.-Set values can only be set on enabled proportional values.The monitor must be configured in channel pairs (for example, channels 1 and 2Can be configured for radial vibration, channels 3 and 4 can be configured forConfigured for thrust position).-When modifying the full scale range, the relevant set pointThe proportional value should be readjusted.-It is best to set the Scale Factor and Trip Multiply values firstZero position value.-3000 (- 18V), 3000 (- 24V), and 330RAM proxies have limited linearityRange. Therefore, care should be taken when selecting full scaleDirect, 1X amplitude (Ampl), 2X amplitude (Ampl), non 1X range

NEW Allen Bradley PowerFlex 700 20BD180A0ANNAND​0 150HP

MINT Allen Bradley PowerFlex 700 20BD248A3ANNAND​0 200HP

MINT Allen Bradley PowerFlex 700 20BD156A3ANNAND​0 125HP

Allen Bradley PowerFlex 700 20BD096A3ANNANB​0/A 75HP

Allen Bradley Powerflex 700 20BE052A0AYNAND​0/A 50 HP

USED Allen Bradley 20DD034A3EYNADA​UE PowerFlex 700 25HP